But you are a professional. You do this:
boot-loader file flash:/5130_24G_4SFP_7.10.R3238.ipe slot 1 main The switch stares at you. It runs a checksum. If it says "Verification passed," you breathe. If it says "Incompatible version," you cry. (This means you downloaded the wrong hardware variant—the 5130 has EI and SI models. You have the wrong one).
The 5130 has a USB port. Copy the .ipe to a FAT32 USB stick, plug it into the switch, and type copy usb0:/firmware.ipe flash:/ . It’s faster and less likely to corrupt. Act III: The Surgery (The Boot Loader Whispers) Here is where most guides lie to you. They say: "Just type boot-loader." hp 5130 switch firmware upgrade
tftp 192.168.1.100 get 5130_24G_4SFP_7.10.R3238.ipe The cursor blinks. This is where you contemplate your life choices. A 30MB file over 100Mbps Ethernet takes 5 seconds. Over a slow TFTP transfer because your laptop is on WiFi? It takes an eternity.
The system is going to reboot. Continue? [Y/N]: As the switch reboots, the fans spin up to jet-engine volume. The console floods with hex codes. You see: But you are a professional
Now, the scary part:
System is starting... Press Ctrl+D to access BASIC-BOOTWARE menu... You ignore that. Ten seconds later, the login prompt appears. You log in. If it says "Verification passed," you breathe
You did it. You monster. Here is the dirty secret: Upgrading the firmware wipes your config if you didn't save it.