Zkteco Ua300 Factory Reset < RECOMMENDED >

| Parameter | Default Value | |-----------|----------------| | IP Address | 192.168.1.201 | | Port | 4370 (TCP) | | Administrator Password | 12345 (or 0000 for some older firmware) | | User Data | None | | Lock Delay | 5 seconds | | Door Sensor | Normally Closed | | Alarm Time | 10 seconds | | Language | English (US) | | Communication Mode | TCP/IP priority |

Document ID: ZK-UA300-RST-2024 Product: ZKTeco UA300 (Fingerprint & RFID Access Control Terminal) Document Type: Troubleshooting & Maintenance Procedure 1. Abstract The ZKTeco UA300 is a standalone access control device combining fingerprint, RFID card, and password authentication. Operational integrity may require a factory reset due to administrator credential loss, configuration errors, or device repurposing. This paper details the two primary methods for executing a factory reset: hardware-based (using the reset button and power cycle) and software-based (via the administrator menu or ZKAccess software). It also covers post-reset behaviors and critical warnings. 2. Introduction Factory resetting the UA300 restores all settings to their original state upon leaving the factory. This action irreversibly deletes all user data (fingerprint templates, card credentials, passwords), access levels, time schedules, and custom network/IP settings. It does not affect the device’s bootloader or firmware version. zkteco ua300 factory reset

If possible, back up user data via ZKAccess 3.5 or ZKTime Web software before resetting. 4. Factory Reset Methods 4.1 Method 1: Hardware Reset (Without Administrator Access) Use this method when the administrator password is unknown. This paper details the two primary methods for